72
Click the Auto Scroll button to switch between Follow, Page, and Off.
• When set to Follow, depending on the zoom setting, the grid will scroll
along in the background, keeping the position marker centered.
• When set to Page, the grid display will "turn over" to follow the position
marker.
• When set to Off, the grid will not move at all.
Click the View button to switch between Split View and Full-Screen View.
• In Split View, the software window will show the grid in the upper half
and the mode-specific controls in the lower half.
• In Full-Screen View, the software window will show the grid only. This
view is useful if you are working with a lot of pads or Tracks and need to
view all of them simultaneously.
Hardware: Press the Shift + Window / Full Screen buttons to switch
between Split View and Full-Screen View.
The top LED next to the MPC logo is the MIDI In LED. It will light up to indicate
the software is receiving MIDI messages from your connected MPC hardware.
The bottom LED next to the MPC logo is the MIDI Out LED. It will light up to
indicate the software is sending MIDI messages out.
To Next Page
Loading...
Need help?
General
