• “pdhPS ASAP” (p. 6-52)
• “ethPS ASAP” (p. 6-52)
• “pdhPath ASAP” (p. 6-53)
• “timing ASAP” (p. 6-54)
• “sdhPRS ASAP” (p. 6-54)
• “sdhMS ASAP” (p. 6-54)
• “sdhMSP ASAP” (p. 6-55)
• “sdhHOPath ASAP” (p. 6-56)
• “sdhLOPath ASAP” (p. 6-56)
• “sdhVCG ASAP” (p. 6-58)
• “sdsl ASAP” (p. 6-59)
dcn ASAP
The following table lists the default alarm severity assignments of the “dcn” ASAP.
Alarm
identifier
“Probable
cause”
Alarm text Alarm
severity
Reporting state
(default setting)
DCN-
BUcLOST
Mandatory IS-IS parameters missing Prompt Reported
DCNcCONF
IS-IS configuration error Prompt Reported
DCNcREPAIR IS-IS Level-2 Area repair, transmission/
configuration error
Deferred Reported
DCNTAPc-
CONF
DCN-Tunnel auto provisioning configuration
error
Deferred Reported
MLQ2
Loss of Q2-communications Information Reported
AITScDCCF DCC Port - Not available Prompt Reported
LANcTRM Q-LAN - Not terminated Information Not Reported
equipment ASAP
The following table lists the default alarm severity assignments of the “equipment”
ASAP.
Alarm identifier
“Probable cause”
Alarm text Alarm
severity
Reporting state
(default setting)
E11XcEQF 1.5 Mbit/s extension board (X16DS1) -
defective
Deferred Reported
E11XcUNI 1.5 Mbit/s extension board (X16DS1) missing Prompt Reported
E11XcWUP Wrong extension board present Prompt Reported
E11XcUPF 1.5 Mbit/s extension board (X16DS1) -
defective
Prompt Reported
Alarm management
Alarm Severity Assignment Profile
....................................................................................................................................................................................................................................
6-48
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
