Show, Clear, and Debug Command Reference
360 Router Configuration Guide
ip-int-name — Only displays the interface information associated with the specified IP interface
name.
Values 32 characters maximum
packet
Syntax packet [ip-int-name | ip-address] [headers] [protocol-id]
no packet [ip-int-name | ip-address]
Context debug>router>ip
Description This command enables debugging for IP packets.
Parameters ip-int-name — Only displays the interface information associated with the specified IP interface
name.
Values 32 characters maximum
ip-address — Only displays the interface information associated with the specified IP address.
headers — Only displays information associated with the packet header.
protocol-id — Specifies the decimal value representing the IP protocol to debug. Well known
protocol numbers include ICMP(1), TCP(6), UDP(17). The no form the command removes
the protocol from the criteria.
Values 0 to 255 (values can be expressed in decimal, hexadecimal, or
binary)
route-table
Syntax route-table [ip-prefix/prefix-length]
route-table ip-prefix/prefix-length longer
no route-table
Context debug>router>ip
Description This command configures route table debugging.
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
Values The following values apply to the 7750 SR and 7950 XRS:
To Next Page
Loading...
