NE management by software application
MPR-e 219
• Expected Rx Radio Link Identifier: this field is the link identifier expected at the
receiving NE (0 to 255).
• Packet Throughput Booster:
In order to improve the use on air bandwidth, the MPT can compress the packet
applying the following principle: whenever a packet is received with a known packet
header at remote site, the MPT saves bandwidth by not transmitting this header each
time. Only some learning bytes allow to index the corresponding known packet
header.
When activated the MPT will compress, when possible, the packet to save air
bandwidth. To activate the Packet Throughput Booster tick the relevant check box in
this field.
Ethernet traffic QoS
This menu allows to:
1. Select the QoS Classification
2. Set the Classification according to the EtherType
3. Set the Scheduling Algorithms
Note: If the Expected Rx Link Identifier is "0", there is no link identifier mismatch
management.
Note: The remote NE must have also enabled its "Packet Throughput Booster" feature for
decompression capabilities.
Note: For the QoS the first match for the classification is done according to 802.1p/DiffServ
(point Select the QoS Classification). If there is no match, the classification is done
according to the EtherType (point Set the Classification according to the EtherType). If there
is no match, the Ethernet frame is sent to the lower-priority queue.
To Next Page
Loading...
