Chapter 8: Building the Stack with Gigabit or 5G Multi-speed Ports
168
5. Enter the SHOW RUNNING-CONFIG INTERFACE command to
display the port configuration on the member switch. Confirm that the
correct copper Gigabit, copper 5G Multi-speed, or Gigabit SFP ports
on the member switch have the STACKPORT command, designating
them as the trunk. Refer to Figure 64 for an example.
Figure 64. SHOW RUNNING-CONFIG INTERFACE Command for
Member Switches
Note the following:
1 - These lines designate the stack ports for the default
provisioned switch. You can ignore these lines on member
switches.
2 - These lines designate the trunk ports for the member switch
you are configuring. The switch ID number in the PORT parameter
should match the ID number of the switch and the port numbers
should be the ports of the trunk. Repeat the procedure if the
display does not include these lines.
6. Go to “What to Do Next” on page 169.
awplus# show running-config interface
interface port1.0.1-1.0.26
switchport
switchport mode access
!
stack enable front-panel-ports
!
interface port1.0.27-1.0.28
stackport
!
interface port2.0.1-2.0.24
switchport
switchport mode access
!
interface port2.0.1-2.0.8
stackport
!
interface port2.0.27-2.0.28
switchport
switchport mode access
!
awplus#
2
1
To Next Page
Loading...
Need help?
General
