Allied Telesis x530 Series - Figure 50: Marking the Locations of the Bracket Holes on a Concrete Wall

Chapter 6: Installing the Switch on a Wall
128

Provide sufficient space from other devices or walls so that you
can access the front and back panels, and for adequate air flow
and ventilation.
Figure 50. Marking the Locations of the Bracket Holes on a Concrete Wall
4. Place the switch on a table.
5. Use a drill and a 1/4-inch carbide drill bit to pre-drill the holes you
marked in step 3. Please review the following guidelines:
 Prior to drilling, set the drill to hammer and rotation mode. The
modes break up the concrete and clean out the hole.
 Clean out the holes with a brush or compressed air.
6. Insert the anchors into the holes.
35179111315171921 23 27/S1
28/S2
25 SFP+
26
AT-x530-28GTXm
16 18 2014
10G/1G
46810122 22 24
FDX HDX COL
1G LINK ACT 100 LINK ACT 5G/2.5G/1G LINK ACT 100 LINK ACT
PORTS 21-24
PORTS 1-20
5G/2.5G/1G/100
CLASS1
LASER PRODUCT
CONSOLE
4596