Chapter 1: Overview
50
The states of the x530-28GSX LEDs are described in Table 16.
S1 and S2 SFP+
Port LEDS
SFP+ ports S1 and S2 on the front panels of the switches can be used
either as regular Ethernet networking ports or as the trunk in a stack of up
to four or eight switches with the VCStack feature. The switches of a
VCStack act as a single virtual unit, synchronizing their actions so that
switching operations, like spanning tree protocols, virtual LANs, and static
port trunks, span across all of the units and ports. For more information,
refer to Chapter 2, “Virtual Chassis Stacking” on page 59.
Table 16. x530-28GSX SFP Network / Stacking LEDs
LED Ports State Description
L/A
1 - 24
SFP
LED
Solid Green The port has established at 1Gbps link to a
network device.
Flashing Green The port is transmitting or receiving data at
1Gbps.
Solid Amber The port has established a 100Mbps link to
a network device.
Flashing Amber The port is transmitting or receiving data at
100Mbps.
25-28
SFP+
LED
Solid Green The port has established a 10Gbps link to
a network device.
Flashing Green The port is transmitting or receiving data at
10Gbps.
Solid Amber The port has established at 1Gbps or link
to a network device.
Flashing Amber The port is transmitting or receiving data at
1Gbps.
Off Possible causes of this state are:
- The port has not established a link with
another network device.
- The LEDs are turned off. To turn on the
LEDs, use the eco-friendly button.
To Next Page
Loading...
