x530 Series Installation Guide for Virtual Chassis Stacking
49
LEDs for the SFP
Ports
The LEDs for the SFP slots on the x530-28GSX Switch are located
between the ports, as shown in Figure 15. Each SFP port has one LED.
The left LED is for the top port, and the right LED is for the bottom port.
Figure 15. SFP Port LEDs on the x530-28GSX Switch
PoE 1 - 48
Solid Green PD On - The switch is delivering power to a
powered device connected to the port.
Solid Amber PD Error - The switch has shut down PoE on the
port because of a fault condition.
Flashing
Amber
PD Max Current - The switch has detected a
powered device on the port but is not delivering
power to it because doing so would exceed its
available power budget.
Off No PD - This LED state can result from the following
conditions:
- The port is not connected to a powered device or
the device is powered off.
- The port is disabled in the management software.
- PoE is disabled on the port.
- The LEDs are turned off. To turn on the LEDs, use
the eco-friendly button.
Table 15. x530-52GPXm Copper Ports 1 - 48 LED Functions (Continued)
LED Ports State Description
SFP Port LEDs
To Next Page
Loading...
