Chapter 4: Installing the Switch on a Table
104
Installing the Rubber Feet on the Switch
The x530-28GPXm, x530-28GTXm, x530-28GSX, x530-52GPXm, and
x530-52GTXm switches come with seven rubber feet in the accessory kit.
The feet, which are reusable, are used when installing the switch on a
table.
Note
Although you cannot stack the switches on top of each other, they
can be placed next to each other.
Note
The following procedure assumes that you have already reviewed
the information and performed the procedures in Chapter 3,
“Beginning the Installation” on page 91.
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
To install the rubber feet on the underside of the switch, perform the
following procedure:
1. Place the switch upside down on a table.
2. Affix the seven rubber feet to the square indentations on the bottom
panel of the switch
3. Turn the switch over and place it on a flat, secure desk or table,
leaving ample space around it for ventilation.
To Next Page
Loading...
Need help?
General
