Allied Telesis x530 Series - Chapter 7: Default 10 Gbps Stacking Port Trunking

131
Chapter 7
Building the Trunk with the Default
SFP+ S1 and S2 10Gbps Stacking Ports
This chapter contains the following procedures:
 “Introduction” on page 132
 “Powering On the Switches Sequentially” on page 133
 “Powering On the Switches Simultaneously” on page 136
 “Starting a Management Session” on page 138
 “Verifying the Stack” on page 143
 “Adding SFP+ Ports to the Stack Trunk” on page 144
 “Powering on a Switch” on page 146