User Manual AMETEK Programmable Power
RS Series 187
RUN SINGLE
RUN SINGLE command will run a single test once. The Dip or Interrupt test is defined by the
DIP TO, NO CYCLES, and START ANGLE parameters. These parameters must be set before
starting the test. The following is a description of these parameters.
DIP TO: The dip voltage level as a percentage of the nominal voltage.
NO CYCLES: The dip duration in cycles.
START ANGLE: The start phase angle of the dip
Note: After each individual run, a 10 second delay is inserted.
To Next Page
Loading...
Need help?
General
