Andreoli Engineering ATOM 1000 - Automatic A;C Controller

ANDREOLI ENGINEERING Operator’s Manual
Self-propelled sprayer ATOM
59/166
3.12.3 Automatic A/C controller
1)
Increase temperature
2)
Reduce temperature
3)
Automatic control of temperature and fans.
Start of diagnostic procedure: keep pressed during start upand release when displays
information about type / version.
Press once again to exit diagnostic.
4)
A/C compressor control.
When A/C symbol is on, compressor is engaged.
When A/C symbol is off, compressor is disengaged.
5)
Not used.
6)
Increase fans speed.
7)
Reduce fans speed.
8)
Temperature control.
Keeping pressed less than 2 seconds, it displays the outside temperature for about 6 seconds.
Keeping pressed more than 2 seconds, it displays the inside temperature for about 6 seconds.
ERRORS
E1
Outside temperature sensor not connected
E2
Outside temperature sensor short - circuited
E3
Inside temperature sensor not connected
E4
Inside temperature sensor short - circuited
E5
Miexd air temperature sensor not connected
E6
Miexd air temperature sensor short - circuited
1
2
3
6
7
8
4
5