ANDREOLI ENGINEERING
Operator’s Manual
Self-propelled sprayer ATOM
Perform bleeding operations as follows:
Stop the engine, remove ignition key.
Wait some minutes for cooling of components.
Put a container under the filter.
Loosen the screw (2).
Manually act on the pump (1) to let air come out of the circuit.
Make sure that from the screw (2) only clean fuel comes out, without air.
Tighten the screw (2).
Clean fuel residues before starting the engine again.
Do NOT loosen any fitting of the common rail high pressure circuit.
7.6.6 Fuel filter – D754IE3
1) Primary fuel filter
2) Manual fuel pump
Follow prescriptions described in previous chapter.
To Next Page
Loading...