Anritsu MS9710C - Page 247

Section 11 LabVIEW Measuring Instrument
11-30
MS9710A Trace ;Set Memory/Trace
MS9710
Trace
This driver switches between data saving memories and selects a display (trace) mode.
Input parameters:
Memory A/B (no change)........... Select a memory for saving data.
Trace Mode (no change)............. Select a trace type (A, B, A & B, A-B, or B-A).
MS9710A Wavelength ;Air/Vacuum
MS9710
Air/Vac
This driver sets the wavelength display mode to “in Air” or “in Vacuum.”
Input parameter:
Air/Vacuum (Air: F) ................... “in Air” or “in Vacuum.”
MS9710A Wavelength ;Center/Start/Stop
MS9710
Center
strt stp
This driver sets and reads center, start, and stop wavelengths.
When no value is input, the previous setting is used.
Input parameters:
Center Wl (nm) (no change) ....... Set a center wavelength.
Start Wl (nm) (no change) .......... Set a start wavelength.
Stop Wl (nm) (no change) .......... Set a stop wavelength.
Output parameters:
Center Wl (nm)........................... Outputs a center wavelength.
Start Wl (nm) .............................. Outputs a start wavelength.
Stop Wl (nm) .............................. Outputs a stop wavelength.
MS9710A Wavelength ;Set Span
MS9710
Span
This driver sets and reads a span wavelength.
When no value is input, the previous setting is used.
Input parameter:
Span (nm) (no change) ............... Set a span wavelength.
Output parameter:
Span (nm) ................................... Outputs a span wavelength.