Anritsu MT8802A - Page 56

Section 6 Correction Software
6-8
[8] Measurement device selection section
This section enables selection of the equipment name of the DUT to be measured. Note
that this program sets different measurement items, depending on the equipment name
selected in this section.
[9] Output Device (Output destination of measured result display section)
This section displays the output destination of the measured results currently set. To
modify the setting, do so in “Settings” in section [1]. See 6.6.4 “Setting Output Desti-
nation of Measured Results” for more information on modification of the output desti-
nation.
[10] Attenuator selection section
This section is displayed when “Receiver” is selected in section [2] and “Item...” is
selected in section [4]. When this item is selected, all the items displayed in section
[12] are selected.
[11] Section to display the number of units for continuous measurement
This section is displayed when “Receiver” is selected in section [2] and “Channel Se-
lector” is selected in section [1]. This program enables continuous measurement of up
to four units by using the channel selector when measurement of the reception system
is selected.
[12] Setup HPF selection section
This section is displayed when “Receiver” is selected in section [2] and “Item...” is
selected in section [4]. When this items is selected, all the relevant file names in sec-
tion [13] are displayed.
[13] Output File Name (Section to display the name of the file to store the correction values)
This section displays the name of the file to store the correction value for each measure-
ment item. This program sets items for which relevant file names are displayed in this
section as the targets of measurement.
[14] Calibration/Frequency Response measurement selection section
Select “Calibration” to calibrate the level using this program. To measure the fre-
quency response after calibration, select “Freq. – Resp.”
[15] Measure (M) (Measurement start button)
This button starts the measurement of items following confirmation of such selected
items on this screen. See 6.7.4 “Items Confirmed Before Start of Measurement” for
more information on items that must be confirmed prior to measurement start.
[16] Exit (Q) (Program quitting button)
This button is used to end this program. See 6.6.12 “Exiting Program” for more infor-
mation on program quitting.