AT&T PC 6300 - Page 108

INSTALLATIONS
16. Replace the lower System Module cover and tighten the two
cover screws.
17. Place the System Module back to its upright position.
18. Connect the cables that were disconnected (Keyboard,
Display, Printer, etc.) back to the rear panel of the System
Module.
19. Plug the ac power cable into the rear panel.
20. Verify that the RAM passes Resident Diagnostics and then
run the Customer Test Diagnostics in the Automatic Mode.
(Refer to Chapter 4.)
3-20
■n
n
0
n
■0
0
n
n
n
n
0
n
n
n
n
n.
n