AT&T PC 6300 - Loading System Test; System Test Diagnostics

DIAGNOSTICS
n
n
n
n
n
n
n
n
n
n
SYSTEM TEST DIAGNOSTICS
The System Test Diagnostics are loaded from a diagnostic diskette.
These tests are designed to enable Service Personnel to identify
failing/marginal modules and verify the modules correct operation
after repairs have been made. Service personnel can select specific
tests to run, depending on the nature of the errors that are
reported. A list of the error messages that may be received is
located at the end of this chapter. For troubleshooting
information associated with the error messages, refer to Chapter 5,
"MAINTENANCE."
Note: It is recommended that you make a copy of your
System Test Diagnostic Diskette. Save the original as a
backup master. Use the copy as the working System Test
Diagnostic Diskette. Make sure the copy is not write
protected.
Loading System Test •
The System Test Diagnostics is loaded as follows:
1. Insert the MS-DOS System Diskette into MFD Unit A and
close the drive door.
2. Turn the System Module power switch ON.
3. After the Resident Diagnostics have successfully been
completed, verify that the Operating System has been
loaded.
4. Remove the MS-DOS System Diskette from MFD Unit A.
4-47
ft