AT&T PC 6300 - Installing DEB Software

INSTALLATIONS
Installing DEB Software
The four steps required to install the DEB device driver are:
3. Edit a special file called CONFIG.SYS to tell the system
where to find the DEB driver.
4. Reboot the system.
The file CONFIG.SYS is processed automatically by the PC each
time the system is started. CONFIG.SYS defines the specific
system to DOS. When a nonstandard device such as the DEB is
used, DOS needs to know where to find the driver for that device.
Then DOS automatically loads the special device as an extension of
itself.
3-90
D
n
n
1. Replace the old version of GWBASIC with the enhanced ^
version that comes with the DEB. ^
2. Copy the file DEDRIVER.DEV onto the system disk. P|
0
n
n
n
n
n
n.
n