AT&T PC 6300 - Resistor Pack or Terminating Resistor; Toshiba Mini-Floppy Disk Unit

APPENDIX A: SWITCHES AND JUMPERS
n
n
n
n
n
n
n
n
n
n
n
n
n ■
n
n
n * Drive B: The resistor pack should be installed in drive B in
a dual floppy drive system (CPU 12).
Resistor Pack or Terminating Resistor
Resistor Pack installation information is as follows:
• Drive A:
The resistor pack should not be installed in
drive A when installing a dual floppy drive system
(CPU-2).
Note: All MFDs come configured for drive B.
Toshiba Mini-Floppy Disk Unit
The standard jumper and DIP switch default settings for the
Toshiba Mini-Floppy Disk Unit are shown in Figure A-30. The
locations with jumpers (jumper caps) are represented by the
darkened areas.
A-39