AT&T PC 6300 - Hard Disk Systems

INSTALLATIONS
n
. ■ ■ . n
Note: If you don't have a CONFIG.SYS file
(and you won't if you copied your original
MS-DOS system diskette), a new file will be j j
created. —
b. Now reboot the system. (Press the RESET button at
the front of the computer or press the Ictri I. I ait I. and
IDEL1 keys simultaneously.)
c. A display of internal boot diagnostic messages will
appear. If these messages do not appear, refer to the
section titled "Troubleshooting DEB Installation" before
adjusting your monitor.
disk.
1. To replace the GWBASIC on the system disk (hard disk)
with the new version of GWBASIC that comes with the
DEB, proceed as follows:
b. Insert the diskette containing the new version of
GWBASIC into drive A.
3-94
0
n
Hard Disk Systems
The following instructions are for systems that include a hard ^
n
a. Go to the directory where your original GWBASIC
resides (or specify the appropriate pathnames).
n
Q
0
n
n
0
n