AT&T PC 6300 - Display and Edit Bad Track Table

DIAGNOSTICS
Display and Edit Bad Track Table
The bad traek table editor allows the user to:
1. Format the bad track
2. Add bad tracks to the table
3. Delete bad tracks from the table
4. Display the bad track table
5. Abort the display and edit bad track.
screen.
are marked. This is usually when the bad track information
provided by the drive manufacturer would be entered.
P/,
P
■n
,n
D
0
This can be done by:
1. Pressing key "4" when the Main Menu is displayed on the
2. In the Low-Level Format after the entire disk is formatted,
the user is prompted to enter the editor before the bad tracks M
0
3. In the Format Bad Tracks operation, the user is prompted to
enter the editor before the bad track information in the table n
is used to reformat the bad tracks. Except for looking over I [
the table before the reformat operation, the editor functions """"
should not be needed. ^
n
G
4-110
n
n
n
A