AT&T PC 6300 - Installing Small Expansion Box

n
n
INSTALLATIONS
n
n
n
n
fl :
n
1
n
n
n
n
rr
ft
Installing Small Expansion Box
The materials required for the installation of the Small Expansion
Box are:
• Small Expansion Box with two signal cables and one power
cable
• Hard Disk Unit Controller
• Medium-sized standard screwdriver
• Clamp for connecting Small Expansion Box to System
Module.
To install the Small Expansion Box;
1. Turn the System Module and all external devices OFF.
2. Unplug the ac power cable from the rear panel.
3. Disconnect all the cables (Display, Keyboard, Printer, etc.)
from the rear panel of the System Module.
4. Loosen the two screws that secure the upper cover.
5. Slide the upper cover forward approximately 0.5 inch and
lift it from the System Module.
3-63