AT&T PC 6300 - Automatic Mode

DIAGNOSTICS
n
Automatic Mode
Pressing y followed by the ENTER key places the test in the
Automatic Mode. A list of the systems hardware is displayed and
you are asked if the list is correct;
n
n
n
n
THE INSTALLED HARDWARE IS:
1 - MAIN BOARD
3 - XXX KB MEMORY (XXX = Total system RAM)
4 - 83 KEY KEYBOARD
5 - XXXX VIDEO SYSTEM (XXXX = COLOR or MONOCHROME)
6 - 1 PARALLEL PORTCS)
7 - 1 SERIAL PORTCS) (USING 82S0)
8 - X 48 TPI FLOPPY DISK DRIVECS) (X-1 or 2)
9 - X HDU DRIVE AND CONTROLLER CX-10 or 20 MB)
IS THE LIST OF HARDWARE CORRECT? Cy - YES,
NO)
After pressing y followed by the ENTER key (correct list), the
following message is displayed.
■«> ATTENTION: SCRATCH DISKETTES MUST BE RE-FORMATTED BEFORE
USE BY YOUR OPERATING SYSTEM, USING YOUR OPERATING SYSTEM
FORMAT COMMAND.
PRESS 'ENTER' KEY TO CONTINUE -
The previous message is to remind the user that scratch diskettes
formatted by the System or Customer Test using the Manual Mode
option 1 of MENU A are not actually MS-DOS formatted and are
to be used only for the execution of floppy disk tests.
4-23
n