AT&T PC 6300 - Page 230

DIAGNOSTICS
Note: The MS-DOS formatted diskettes can be used for
testing. After testing, all test scratch diskettes must be
reformatted under MS-DOS to operate.
Insert a formatted diskette in the MFD Unit(s). After you have
inserted the formatted diskette(s) and pressed the ENTER key,
the tests start running in the automatic mode.
ERROR - HARDWARE DOES NOT AGREE WITH CONFIGURATION TESTS
■> Record any differenceCa) between the llat of the Hardware
on the acreen and the hardware that ahould be llated.
PROGRAM TERMINATED!! !
A>_
1. Check DIP switches on Motherboard (see Appendix A).
2. Use system test to add a module to the configuration and then
test the module.
3. Call "Hot-Line" at 1-800-922-0354.
4-24
n
: i i
n
fi
H;
If you discover that the system hardware does not match the
hardware list, press the n key followed by the ENTER key. The
following message will be displayed: 1*?
n
If the customer test does not list the correct hardware ^
configuration, proceed as follows:
rr
rr
n
n.