AT&T PC 6300 - Serial Port(S) Test; 48 TPI Floppy Disk Test

1 i
DIAGNOSTICS
n
n,
n
^ I
i V
n
n
n
1
J
Serial Port(s) Test
The Serial Port(s) test checks the Serial interface.
48 TPI Floppy Disk Test
The user is asked to insert a formatted MS-DOS scratch diskette
in the drive(s). The diskette(s) must be formatted in an MS-DOS
environment using the format utility (format a: or format b;).
^ The following tests are then carried out:
• Sequential Write
• Sequential Read and Data Check.
V I
Sequential Write: This test writes a test pattern to the diskette
n starting with the outermost track and continuing to the innermost
\ \ track.
^ Sequential Read and Data Check: This test reads the
' 1 diskette starting with the outermost track and continuing to the
innermost track.
4-37