AT&T PC 6300 - Replacing Fan

MAINTENANCE
Replacing Fan
1. Perform the procedures for removing the power supply.
2. After the power supply has been removed, use a pair of side
cutters to cut the rubber inserts securing the fan to the rear
panel.
3. Remove the fan.
4. Slide the new rubber inserts through the holes in the rear
panel and carefully pull them through (from the outside)
until they are flush with the inside of rear panel.
5. Align the replacement fan with the inserts making sure the
power connectors for the fan are at the top.
6. Slide new rubber inserts through the holes in the fan until
they are protruding out of the rear of the fan.
7. Carefully pull the inserts through the fan until they are
holding the fan in place.
Perform procedures for removing the power supply in reverse
order to reinstall the power supply.
5-156
n
n
n
n
0
n
n.
n
n
M
n
n
n
0
0
n