AT&T PC 6300 - Page 114

INSTALLATIONS
15. Remove the wrist strap (if wrist strap was used).
16. Using a screw and screwdriver, secure the Memory
Expansion Board by fastening the retaining bracket to the
rear panel.
17. Replace the upper System Module cover and tighten the two
cover screws.
18. Connect the cables that were disconnected (Keyboard,
Display, Printer, etc.) back to the rear panel of the System
Module.
3-26
0
0
n
D
0
n
n
19. Plug the ac power cable into the rear panel.
I
20. Verify that the RAM passes the Resident Diagnostics and
then run Customer Test Diagnostics in the Automatic Mode.
(Refer to Chapter 4.) 1 i
^ 0
n
n
0
n.
0
n
n