AT&T PC 6300 - Page 256

DIAGNOSTICS
MENU B
After indicating if the tests were to be run one or more times,
MENU B appears and your screen should look similar to the
following typical example. The actual screen display is determined
by the machine configuration.
1 - MAIN BOARD
3 - XXX KB MEMORY {XXX = total system RAM)
4 -83 KEY KEYBOARD
5 - XXXX VIDEO SYSTEM (XXXX = COLOR or MONOCHROME)
6 - PARALLEL PORKS)
7 - SERIAL PORKS) CUSING 82S0)
8 - X 48TPI FLOPPY DISK DRIVECS) CX-1 or 2)
9 - X MB HDU DRIVE AND CONTROLLER (X-10 or 20 MB)
IS THE LIST OF HARDWARE CORRECT? X'y' - YES,
NO)
If you press the y key, followed by the ENTER key, you are taken
to MENU D. In MENU D, you must indicate if all hardware is to
be tested or if specific modules are to be tested.
If you press the n key, followed by the ENTER key, the following
message is displayed:
ERROR - HARDWARE DOES NOT AGREE WITH CONFIGURATION TESTS
DO YOU WANT TO ADD ANY HARDWARE TO THE LIST ' ('y'- YES,'
If you press the n key, followed by the ENTER key, MENU D is
displayed. If the y key is pressed, followed by the ENTER key,
you are taken to MENU C.
0
n
0
n
n
D
n
n
Q
n
R
1 !
n
4-50
n
n
n
n