AT&T PC 6300 - Page 261

n
n
n
DIAGNOSTICS
If you press the 0 key followed by the ENTER key, the following
menu is displayed for the selection of the specific disk:
n
n
n
n
n
n
n
'
SELECT ERROR LOG DRIVE:
0 - drive 'A'
1 - drive 'B'
2 - drive 'C
ENTER DESIRED ACTION -
When you select a drive to be used as the logging device, the
system attempts to create a file called errordog. If an MFD Unit
is specified, the write-protect tab must not be present on the
diskette used. However, care must be taken if the floppy disk tests
are to be run because the contents of the diskette may be erased.
If you press the 1 key, followed by the ENTER key, the list of
logged failures is displayed from the diskette or hard disk.
If you press the 2 key, followed by the ENTER key, error logging
is stopped.
If you press the 3 key, followed by the ENTER key, a 24-hour
timer is initialized at 00:00:00.
If you press the 4 key, followed by the ENTER key, the current
value of the 24-hour timer is displayed.
If you press the 5 key, followed by the ENTER key, you are taken
to the Test Options Menu, MENU A.
n
n
n
n
n
4-55