AT&T PC 6300 - Page 312

DIAGNOSTICS
If the user responds "Y" or "y", followed by the ENTER key, the
program will continue, and the following message will request the
operator's confirmation:
WARNING - THIS OPERATION ERASES ALL FILES.
....> type M234' TO CONFIRM SELECTION
....> type '0' TO ABORT THE OPERATION
With a DTC or WD controller, the "Interleave Factor" will always
be by definition six (6) and the following message will be
generated:
HARDWARE TESTS SUGGESTS BEST INTERLEAVE FACTOR IS *M:S"
DO YOU WISH TO SPECIFY A DIFFERENT INTERLEAVE FACTOR CY or Nl
0
n
u
0
n
n
f!
1
n
a. If the user responds "N" or "n", followed by the ENTER key,
the established value for "X" by the "Optimal Interleave
Factor" procedure will be used as the interleave factor.
b. If the user responds "Y" or "y", followed by the ENTER key,
the following message is displayed:
ENTER AN INTERLEAVE FACTOR (S, S, 4 >?
0
A
4-106
n
' , I