Digital Video Recorder
25
DVRNS Setup
Highlight the DVRNS tab, and the DVRNS screen displays.
Figure 31 ─ DVRNS setup screen.
NOTE: When LAN settings have been changed, set up the DVRNS after saving your LAN changes
by highlighting Save and pressing the
button.
Highlight Use DVR Name Service and press the button to toggle between On and Off.
NOTE: The DVRNS (DVR Name Service) allows the DVR to use Dynamic IP addresses for remote
connection. When this feature is On, you can access your DVR remotely using the DVR name
instead of its IP address. For the DVRNS feature, the DVR should be registered on the DVRNS
server.
Highlight the box beside DVRNS Server and press the button. A virtual keyboard appears allowing
you to enter the IP address or domain name of the DVRNS server.
NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your
network administrator.
NOTE: You can use the domain name instead of IP address if you already set up the DNS Server
when setting up the LAN.
Highlight the box beside Port and press the
button. Set the port number of the DVRNS server using
the Up and Down arrow buttons to increase or decrease the numbers.
Highlight Use NAT and press the
button to toggle between On and Off.
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’
instructions for the proper network settings.
Highlight the box beside DVR Name and press the button. A virtual keyboard appears allowing you
to enter the DVR name to be registered on the DVRNS server.
Highlight the Check box and press the
button to check whether or not the name you entered can be
used.
To Next Page
Loading...