Digital Video Recorder
37
Highlight the + and press the
button to add a schedule item.
Highlight the box under the Day heading and press the
button to change the days that the scheduled
recording will take place. Choose from: Sun, Mon, Tue, Wed, Thu, Fri, Sat, M~F, Hol and All.
Highlight the box under the Range heading and press the
button to change the time range that the
scheduled recording will take place. The smallest time segment you can use is 15 minutes.
Highlight the box under the Mode heading and press the
button to change the recording mode that will
be used. Choose from: No Record, Time, Event and Time & Event.
When the DVR is in the No Record mode, it will not record during the preset day and time range as long
as the
PANIC button is not pressed. Use the No Record mode when you do NOT want the DVR to
record during certain times.
When the DVR is in the Time mode, the
icon displays at the top-left corner of the screen. The DVR
will record and displays the
icon at the top-left corner of the screen during the scheduled times.
When the DVR is in the Event mode, the red
icon displays at the top-left corner of the screen. The
DVR will record and displays the icon at the top-left corner of the screen when any event occurs.
When the DVR is in the Pre-Event recoding mode, the yellow icon displays when there is no event,
and the DVR is not recording. When the DVR is in the Pre-Event mode, the red
and display when
any event occurs and the DVR starts recoding.
When the DVR is in the Time & Event mode, the DVR will follow the Time settings and the
icon
displays. The DVR follows the Event settings and the
icon displays.
Highlight the box under the Channels heading and press the
button to select which cameras will be
recorded.
Highlight the box under the Settings heading and press the
button to define the recording settings.
You can set the ips and Quality of the recording for any modes you set up in the Mode column. If you do
not set the ips and Quality in the Settings column, the DVR will follow the default settings. See below for
details.
Highlight the box under the
heading and press the button to delete the recording settings. You will
be asked to confirm that you want to delete the settings.
Highlight Default… and press the
button. The Default screen appears.
Figure 51 ─ Default setup screen.
You can save your changes by highlighting Save and pressing the button. Selecting Cancel exits the
screen without saving the changes.
Highlighting boxes under ips and pressing the button allows you
to set the images per second for Time and Event recording. You can
select from 0.10 to 30.0 images per second. Highlighting boxes
under Quality and pressing the
button allows you to set the
recorded image quality for Time and Event recording. You can
select from: Very High, High, Standard and Basic.
To Next Page
Loading...