Digital Video Recorder
49
Highlight the box beside Alarm-Out and press the button. A list of Alarm Outputs appears. You can
associate Alarm-Outs with the Text Input as you wish. When the DVR detects text input, it triggers
output signals on the associated Alarm-Out connectors. You can also have the DVR’s internal buzzer
sound if text input is detected.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event
mode in the Alarm-Out setup screen (Schedule tab).
Highlight the box beside Notify and press the
button. You can toggle the entire list On and Off by
highlighting Notification and pressing the button. You can toggle the individual items On and Off by
highlighting that item and pressing the button. Highlight OK and press the button to accept your
changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup
screen and the DVR should be registered in the RAS (Remote Administration System).
Figure 72 ─ Text-In Actions 2 screen.
Highlight the desired box under the PTZ heading, and press the button. A list of PTZ presets appear.
Select the preset positions for each PTZ camera, where you want PTZ cameras to move to when the DVR
detects text input.
Highlight the box beside Spot Monitor and press the
button. A list of a SPOT monitor and cameras
appears. A SPOT monitor can be associated with a camera. The DVR will display the associated camera
on the SPOT monitor whenever it detects an input on the selected text-in device.
You can save your Text-In changes by highlighting Save and pressing the
button. Selecting Cancel
exits the screen without saving the changes.
To Next Page
Loading...