Version 5.8 103 September 2009
SIP User's Manual 3. Web-Based Management
Parameter Description
Serving IP Group
[Account_ServingIPGroup]
The destination IP Group ID (defined in ''Configuring the IP
Groups'' on page 99) to where the RE
GISTER requests (if
enabled) are sent or Authentication is performed. The actual
destination to where the REGISTER requests are sent is the IP
address defined for the Proxy Set ID (refer to ''Configuring the
Proxy Sets Table'' on page 95) a
ssociated with this IP Group. This
occurs only in the following conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the
'Trunk Group Settings' table (refer to ‘‘Configuring the Hunt
Group Settings’’ on page 150).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served
Trunk Group and Serving IP Group, the username and password
for digest authentication defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the 'Hunt Group Settings' table or 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table''
on page 131). For IP-to-Te
l calls, the Serving IP Group is the
'Source IP Group ID' defined in the 'IP to Hunt Group Routing'
table (refer to ''Configuring the IP to Trunk Group Routing'' on
page 135).
Note: If no match is found in this table for incoming or outgoing
calls, the username and password defined in the 'Authentication'
table (refer to Configuring Authentication on page 142) or the
global p
arameters (UserName and Password) defined on the
'Proxy & Registration' page.
Username
[Account_Username]
Digest MD5 Authentication user name (up to 50 characters).
Password
[Account_Password]
Digest MD5 Authentication password (up to 50 characters).
Host Name
[Account_HostName]
Defines the Address of Record (AOR) host name. It appears in
REGISTER From/To headers as ContactUser@HostName. For
successful registrations, this HostName is also included in the
INVITE request's From header URI. If not configured or if
registration fails, the 'SIP Group Name' parameter from the ‘IP
Group’ table is used instead.
This parameter can be up to 49 characters.
Register
[Account_Register]
Enables registration.
[0] No = Don't register
[1] Yes = Enables registration
When enabled, the device sends REGISTER requests to the
Serving IP Group. In addition, to activate registration, you also
need to set the parameter 'Registration Mode' to 'Per Account' in
the 'Hunt Group Settings' table for the specific Hunt Group. The
Host Name (i.e., host name in SIP From/To headers) and Contact
User (user in From/To and Contact headers) are taken from this
table upon a successful registration. See the example below:
REGISTER sip:audiocodes SIP/2.0
Via: SIP/2.0/UDP
10.33.37.78;branch=z9hG4bKac1397582418
To Next Page
Loading...
Need help?
General
