SIP User's Manual 40 Document #: LTRT-65412
MP-11x & MP-124
3.1.6 Searching for Configuration Parameters
The Web interface provides a search engine that allows you to search any ini file parameter
that is configurable by the Web interface (i.e., has a corresponding Web parameter). You
can search for a specific parameter (e.g., "EnableIPSec") or a sub-string of that parameter
(e.g., "sec"). If you search for a sub-string, all parameters that contain the searched sub-
string in their names are listed.
¾ To search for ini file parameters configurable in the Web interface:
1. On the Navigation bar, click the Search tab; the Search engine appears in the
Navigation pane.
2. In the 'Search' field, enter the parameter name or sub-string of the parameter name
that you want to search. If you have performed a previous search for such a
parameter, instead of entering the required string, you can use the 'Search History'
drop-down list to select the string (saved from a previous search).
3. Click Search; a list of located parameters based on your search appears in the
Navigation pane.
Each searched result displays the following:
• ini file parameter name
• Link (in green) to its location (page) in the Web interface
• Brief description of the parameter
4. In the searched list, click the required parameter (link in green) to open the page in
which the parameter appears; the relevant page opens in the Work pane and the
searched parameter is highlighted for easy identification, as shown in the figure below:
Figure 3-13: Searched Result Screen
Note: If the searched parameter is not located, a notification message is displayed.
To Next Page
Loading...
Need help?
General
