SIP User's Manual 168 Document #: LTRT-65412
MP-11x & MP-124
3.4.1.3.3 Saving Configuration
The 'Maintenance Actions' page allows you to save (burn) the current parameter
configuration (including loaded auxiliary files) to the device's non-volatile memory (i.e.,
flash). The parameter modifications that you make throughout the Web interface's pages
are temporarily saved (to the volatile memory - RAM) when you click the Submit button on
these pages. Parameter settings that are only saved to the device's RAM revert to their
previous settings after a hardware/software reset (or power failure). Therefore, to ensure
that your configuration changes are retained, you must save them to the device's flash
memory using the burn option described below.
¾ To save the changes to the non-volatile flash memory :
1. Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 164).
2. Under the 'Save Configuration' group, click the BURN button; a confirmation message
appears when the configuration successfully saves.
Notes:
• Saving configuration to the non-volatile memory may disrupt current
traffic on the device. To avoid this, disable all new traffic before saving,
by performing a graceful lock (refer to ''Locking and Unlocking the
Device'' on page 166).
• Throughout the Web interface, parameters preceded by the lightning
symbol are not applied on-the-fly and require that you reset the device for
them to take effect (refer to ''Resetting the Device'' on page 165).
3.4.2 Software Update
The Software Update menu allows you to upgrade the device's software by loading a new
cmp file (compressed firmware) along with the ini file and a suite of auxiliary files. This
menu includes the following page items:
Load Auxiliary Files (refer to ''Loading Auxiliary Files'' on page 168)
Software
Upgrade Wizard (refer to ''Software Upgrade Wizard'' on page 171)
Config
uration File (refer to ''Backing Up and Restoring Configuration'' on page 175)
To Next Page
Loading...
Need help?
General
