Version 5.8 51 September 2009
SIP User's Manual 3. Web-Based Management
3.1.8.3 Creating a Login Welcome Message
You can create a Welcome message box (alert message) that appears after each successful login to
the device's Web interface. The ini file table parameter WelcomeMessage allows you to create the
Welcome message. Up to 20 lines of character strings can be defined for the message. If this
parameter is not configured, no Welcome message box is displayed after login.
An example of a Welcome message is shown in the figure below:
Figure 3-24: User-Defined Web Welcome Message after Login
Table 3-4: ini File Parameter for Welcome Login Message
Parameter Description
WelcomeMessage
Defines the Welcome message that appears after a successful login to the
Web interface. The format of this parameter is as follows:
[WelcomeMessage]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
[\WelcomeMessage]
For Example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
WelcomeMessage 1 = "*********************************";
WelcomeMessage 2 = "********* This is a Welcome message **";
WelcomeMessage 3 = "*********************************";
[\WelcomeMessage]
Note: Each index represents a line of text in the Welcome message box.
Up to 20 indices can be defined.
To Next Page
Loading...
Need help?
General
