SIP User's Manual 408 Document #: LTRT-65412
MP-11x & MP-124
9.6.2 FXO Operations for Tel-to-IP Calls
The FXO device provides the following FXO operating modes for Tel-to-IP calls:
Automatic Dialing (refer to ''Automatic Dialing'' on page 408)
Colle
cting Digits Mode (refer to ''Collecting Digits Mode'' on page 408)
Ring
Detection Timeout (refer to ''Ring Detection Timeout'' on page 411)
FXO Supple
mentary Services (refer to ''FXO Supplementary Services'' on page 409)
• Hold/Trans
fer Toward the Tel side
• Hold/Transfer Toward the IP side
• Blind Transfer to the Tel side
9.6.2.1 Automatic Dialing
Automatic dialing is defined using the ini file parameter table TargetOfChannel (refer to
Analog Telephony Parameters) or the embedded Web server's 'Automatic Dialing' screen
(refer to ''Automatic Dialing'' on page 143).
The SIP call flow diagram below illustrates Automatic Dialing.
Figure 9-9: Call Flow for Automatic Dialing
To Next Page
Loading...
