Version 5.8 207 September 2009
SIP User's Manual 5. Element Management System (EMS)
6. Select the tabs arrow button, and then from the shortcut menu, choose Unit Value; the
'SNMPv3 Users' table is refreshed with the values that you entered in Step 3.
7. Click the Save button; the EMS and the device are now synchronized.
5.8.3 Configuring SNMPv3 to Operate with Non-Configured SNMPv3
System
The procedure below describes how to configure SNMPv3 using the EMS.
¾ To configure the device to operate with SNMPv3 via EMS (to a non-
configured System):
1. In the MG Tree, select the Region to which the device belongs; the MGs List appears
in the Configuration pane, displaying the devices defined for the Region.
2. In the MGs List, right-click the required device, and then from the shortcut menu, point
to Configuration, and then click Snmp Configuration; the MG Information screen
appears.
Figure 5-8: MG Information Window
3. Select the SNMPv3 option.
4. Configure the SNMPv3 fields, and then select the Update Media Gateway SNMP
Settings check box.
5. Click OK; the 'Results Table' window appears displaying the update progress.
6. Click Done when complete.
7. In the MGs List, double-click the device; the Tab bar appears.
8. Open the 'SNMPv3 Users' screen (Network Provisioning frame > SNMPv3 Users
tab).
To Next Page
Loading...
