Name: AudioCodes MP-124
Brand: AudioCodes
Rating: 4 (1 reviews)

To Next Page

To Previous Page

SIP User's Manual 448 Document #: LTRT-65412

MP-11x & MP-124

9.21.6 FXO Gateway Configuration

The procedure below describes how to configure the FXO device (to which the PBX is

directly connected).

¾ To configure the FXO device:

1. In the ‘Endpoint Phone Numbers’ page, assign the phone numbers 200 to 207 to the

device’s FXO endpoints.

Figure 9-30: Configuring FXO Endpoints

2. In the ‘Automatic Dialing’ page, enter the phone numbers of the FXS device in the

‘Destination Phone Number’ fields. When a ringing signal is detected at Port #1, the

FXO device automatically dials the number ‘100’.

Figure 9-31: Configuring FXO Automatic Dialing

3. In the ‘Tel to IP Routing’ page, enter 10 in the ‘Destination Phone Prefix’ field, and the

IP address of the FXS device (10.1.10.3) in the field ‘IP Address’.

Figure 9-32: FXO Tel-to-IP Routing Configuration

4. In the ‘FXO Settings’ page (refer to ''Configuring the FXO Parameters'' on page 155),

set the parameter ‘Dialing Mode’ to ‘Two Stages’ (IsTwoStageDial = 1).

Other manuals for AudioCodes MP-124

Questions and Answers:

Need help?

Do you have a question about the AudioCodes MP-124 and is the answer not in the manual?

General