Version 5.8 165 September 2009
SIP User's Manual 3. Web-Based Management
3.4.1.3 Maintenance Actions
The 'Maintenance Actions' page allows you to perform the following operations:
Reset the device (refer to ''Resetting the Device'' on page 165)
Lock an
d unlock the device (refer to ''Locking and Unlocking the Device'' on page 166)
Save the conf
iguration to the device's flash memory (refer to ''Saving Configuration'' on
page 167)
¾ To access the 'Maintenance Actions' page:
On the Navigation bar, click the Management tab, and then in the Navigation tree,
select the Management Configuration menu, and then choose the Maintenance
Actions page item.
Figure 3-99: Maintenance Actions Page
3.4.1.3.1 Resetting the Device
The 'Maintenance Actions' page allows you to remotely reset the device. In addition, before
resetting the device, you can choose the following options:
Save the device's current configuration to the device's flash memory (non-volatile).
Perform a graceful shutdown, i.e., device reset starts only after a user-defined time
expires (i.e., timeout) or after no more active traffic exists (the earliest thereof).
¾ To reset the device:
1. Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 164).
2. Under the 'Reset Configuration' group, from the 'Burn To FLASH' drop-down list, select
one of the following options:
• 'Yes': The device's current configuration is saved (burned) to the flash memory
prior to reset (default).
• 'No': Resets the device without saving the current configuration to flash (discards
all unsaved modifications).
To Next Page
Loading...
