Version 5.8 121 September 2009
SIP User's Manual 3. Web-Based Management
¾ To configure the Stand-Alone Survivability parameters:
1. Open the 'SAS Configuration' page (Configuration tab > Protocol Configuration
menu > SAS submenu > Stand Alone Survivability page item).
Figure 3-72: SAS Configuration Page
2. Configure the parameters as described in ''SIP Configuration Parameters'' on page
252.
3. Click the Submit button to apply your ch
anges.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 167.
To c
onfigure the SAS Routing table, under the SAS Routing group, click the SAS Routing
Table
button to open the 'IP2IP Routing Table' page. For a description of this table,
refer to ''Configuring the IP2IP Routing TablE (SAS)'' on page 122.
To Next Page
Loading...
