EasyManuals Logo

AudioCodes MP-124 User Manual

AudioCodes MP-124
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
Version 5.8 137 September 2009
SIP User's Manual 3. Web-Based Management
Parameter Description
[1] Route calls after manipulation = IP-to-Tel calls are routed
after the number manipulation rules are applied.
Dest. Host Prefix
[PstnPrefix_DestHostPrefix]
The request URI host name prefix of the incoming SIP INVITE
message. If this routing rule is not required, leave the field empty.
Note: For notations representing multiple numbers, refer to ''Dialing
Plan Notation for Routing and Manipulation'' on page 377. Ho
wever,
the asterisk (*) wildcard cannot be used to depict any source host
prefix.
Source Host Prefix
[PstnPrefix_SrcHostPrefix]
The From URI host name prefix of the incoming SIP INVITE
message. If this routing rule is not required, leave the field empty..
Notes:
For notations representing multiple numbers, refer to ''Dialing
Plan Notation for Routing and Manipulation'' on page 377.
Ho
wever, the asterisk (*) wildcard cannot be used to depict any
source host prefix.
If the P-asserted-ID header is present in the incoming INVITE
message, then the parameter 'Source Host Prefix' is compared to
the P-Asserted-ID URI hostname and not to the From header.
Dest. Phone Prefix
[PstnPrefix_DestPrefix]
Represents a called telephone number prefix.
The prefix can be 1 to 49 digits long.
Note: For notations representing multiple numbers, refer to ''Dialing
Plan Notation for Routing and Manipulation'' on page 377.
Source Phone Prefix
[PstnPrefix_SourcePrefix]
Represents a calling telephone number prefix.
The prefix can be 1 to 49 digits long.
Note: For notations representing multiple numbers, refer to ''Dialing
Plan Notation for Routing and Manipulation'' on page 377.
Source IP Address
[PstnPrefix_SourceAddress]
The source IP address of an IP-to-Tel call (obtained from the
Contact header in the INVITE message) that can be used for routing
decisions.
Notes:
You can configure from where the source IP address is obtained,
using the parameter SourceIPAddressInput (refer to ''Routing
General Parameters'' on page 130).
The source IP address can include the "x" wildcard to represent
single digits. For example: 10.8.8.xx represents all the addresses
between 10.8.8.10 to 10.8.8.99.
The source IP address can include the asterisk (*) wildcard to
represent any number between 0 and 255. For example, 10.8.8.*
represents all addresses between 10.8.8.0 and 10.8.8.255.
Hunt Group ID
[PstnPrefix_TrunkGroupId]
The Hunt Group to which incoming SIP calls are assigned that
match all or any combination (including only a single parameter) of
the parameters described above.
IP Profile ID
[PstnPrefix_ProfileId]
The IP Profile (configured in ''Configuring P Profiles'' on page 110)
that is assigned to the routing rule.

Table of Contents

Other manuals for AudioCodes MP-124

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MP-124 and is the answer not in the manual?

AudioCodes MP-124 Specifications

General IconGeneral
ModelMP-124
CategoryGateway
Analog Ports24 FXS
Ethernet Ports2
Protocol SupportSIP, H.323
Fax SupportT.38, G.711 pass-through
Power Supply100-240VAC, 50-60Hz
Operating Temperature0°C to 40°C
Voice CodecsG.711, G.729, G.723.1, G.726
ManagementSNMP
Storage Temperature-20°C to 70°C
Humidity10% to 90%, non-condensing
Network Interface10/100Base-T Ethernet

Related product manuals