SIP User's Manual 152 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
[1] Cyclic Ascending (default)
[2] Ascending
[3] Cyclic Descending
[4] Descending
[5] Dest Number + Cyclic Ascending
[6] By Source Phone Number
Registration Mode
[TrunkGroupSettings_Regist
rationMode]
Registration method for the Hunt Group:
[1] Per Gateway = Single registration for the entire device
(default). This mode is applicable only if a default Proxy or
Registrar IP are configured, and Registration is enabled (i.e.,
parameter IsRegisterUsed is set to 1). In this mode, the SIP URI
user part in the From, To, and Contact headers is set to the
value of the global registration parameter GWRegistrationName
(refer to ''Configuring Proxy and Registration Parameters'' on
page 94) o
r username if GWRegistrationName is not
configured.
[0] Per Endpoint = Each channel in the Hunt Group registers
individually. The registrations are sent to the ServingIPGroupID
if defined in the table, otherwise to the default Proxy, and if no
default Proxy, then to the Registrar IP.
[4] Don't Register = No registrations are sent by endpoints
pertaining to the Hunt Group. For example, if the device is
configured globally to register all its endpoints (using the
parameter ChannelSelectMode), you can exclude some
endpoints from being registered by assigning them to a Hunt
Group and configuring the Hunt Group registration mode to
'Don't Register'.
[5] Per Account = Registrations are sent (or not) to an IP Group,
according to the settings in the Account table (refer to
''Configuring the Account Table'' on page 102).
Notes:
To enable Hunt Group registrations, configure the global
parameter IsRegisterNeeded to 1. This is unnecessary for 'Per
Account' registration mode.
If no mode is selected, the registration is performed according
to the global registration parameter ChannelSelectMode (refer
to ''Configuring Proxy and Registration Parameters'' on page
94).
If the device is configured globally (ChannelSelectMode) to
register Per Endpoint, and a Hunt Group comprising four FXO
endpoints is configured to register Per Gateway, the device
registers all endpoints except the first four endpoints. The Hunt
Group of these four endpoints sends a single registration
request.
To Next Page
Loading...
Need help?
General
