AudioCodes MP-124 User Manual

Version 5.8 231 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
Customized Web Appearance Parameters
For detailed information on customizing the Web interface interface, refer to ''Customizing the Web
Interface'' on page 48.
[WelcomeMessage]
This ini file table parameter configures the Welcome message that
appears after a Web interface login. The format of this parameter is as
follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "..." ;
WelcomeMessage 2 = "..." ;
WelcomeMessage 3 = "..." ;
[\WelcomeMessage]
For Example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message ***" ;
WelcomeMessage 3 = "**********************************" ;
[\WelcomeMessage]
Notes:
 Each index represents a line of text in the Welcome message box.
Up to 20 indices can be defined.
 If this parameter is not configured, no Welcome message is
displayed.
 For a description on using ini file table parameters, refer to ''Format of
ini File Table Parameters'' on page 191.
[UseProductName]
Determines whether the UserProductName text string is displayed
instead of the default product name.
 [0] = Disabled (default).
 [1] = Enables the display of the user-defined UserProductName text
string (in the Web interface interface and in the extracted ini file).
If enabled, the UserProductName text string is displayed instead of the
default product name.
[UserProductName]
Text string that replaces the default product name that appears in the
Web interface (upper right-hand corner) and the extracted ini file.
The default is 'MediaPack'.
The string can be up to 29 characters.
[UseWebLogo]
Determines whether the Web interface displays a logo image or text.
 [0] = Logo image is used (default).
 [1] = Text string is used instead of a logo image. AudioCodes' default
logo (or any other logo defined by the LogoFileName parameter) is
replaced with a text string defined by the WebLogoText parameter.
[WebLogoText]
Text string that replaces the logo image. The string can be up to 15
characters.

AudioCodes MP-124 Specifications

General

Model	MP-124
Category	Gateway
Analog Ports	24 FXS
Ethernet Ports	2
Protocol Support	SIP, H.323
Fax Support	T.38, G.711 pass-through
Power Supply	100-240VAC, 50-60Hz
Operating Temperature	0°C to 40°C
Voice Codecs	G.711, G.729, G.723.1, G.726
Management	SNMP
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%, non-condensing
Network Interface	10/100Base-T Ethernet