SIP User's Manual 262 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
[EnableDelayedOffer]
Determines whether the device sends the initial INVITE
message with or without an SDP. Sending the first INVITE
without SDP is typically done by clients for obtaining the
far-end's full list of capabilities before sending their own
offer. (An alternative method for obtaining the list of
supported capabilities is by using SIP OPTIONS, which is
not supported by every SIP agent.)
[0] = The device sends the initial INVITE message with
an SDP (default).
[1] = The device sends the initial INVITE message
without an SDP.
[AnonymousMode]
Determines the source IP address that appears in the SIP
From header.
[0] = No IP address appears in the From header;
instead, the string "Anonymous.invalid" appears
(default).
[1] = Device's IP address is entered in the From header.
EMS: P Asserted User Name
[PAssertedUserName]
Defines a 'representative number' (up to 50 characters) that
is used as the User Part of the Request-URI in the P-
Asserted-Identity header of an outgoing INVITE (for Tel-to-
IP calls).
The default value is NULL.
EMS: Use URL In Refer To Header
[UseAORInReferToHeader]
Defines the source for the SIP URI set in the Refer-To
header of outgoing REFER messages.
[0] = Use SIP URI from Contact header of the initial call
(default).
[1] = Use SIP URI from To/From header of the initial
call.
EMS: Use To Header As Called Num
[IsUseToHeaderAsCalledNumber]
Determines whether the called number is set in the user
part of the To header.
[0] = Sets the destination number to the user part of the
Request-URI for IP-to-Tel calls, and sets the Contact
header to the source number for Tel-to-IP calls (default).
[1] = Sets the destination number to the user part of the
To header for IP-to-Tel calls, and sets the Contact
header to the username parameter for Tel-to-IP calls.
EMS: Enable P Time
[EnablePtime]
Determines whether the ptime header is included in the
SDP.
[0] = Remove the ptime header from SDP.
[1] = Include the ptime header in SDP (default).
Enable User-Information Usage
[EnableUserInfoUsage]
Enables or disables usage of the User Information loaded
to the device in the User Information auxiliary file. (For a
description on User Information, refer to ''Loading Auxiliary
Files'' on page 168.)
[0] Disable = Disabled (default).
[1] Enable = Enabled.
To Next Page
Loading...
