AudioCodes MP-124 - Page 292

SIP User's Manual 292 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
cpc=test 3 Test user
cpc=operator 5 Operator
cpc=data 6 Data call
cpc=payphone 7 Payphone user
Notes:
 This parameter is applicable only to FXS interfaces.
 For this parameter to be enabled, you must also set the
parameter EnableCallingPartyCategory to 1.
[EnableCallerIDTypeTwo]
Disables the generation of Caller ID type 2 when the phone is
off-hooked. Caller ID type 2, also known as off-hook Caller ID
is sent to a currently busy telephone to display the caller ID of
the waiting call.
 [0] = Caller ID type 2 isn't played.
 [1] = Caller ID type 2 is played (default).
[AnalogCallerIDTimingMode]
Determines when Caller ID is generated.
 [0] = Caller ID is generated between the first two rings
(default).
 [1] = The device attempts to find an optimized timing to
generate the Caller ID according to the selected Caller ID
type.
Notes:
 This parameter is applicable only to FXS interfaces.
 When used with distinctive ringing, the Caller ID signal
doesn't change the distinctive ringing timing.
 For this parameter to take effect, a device reset is required.
[BellcoreCallerIDTypeOneSubSta
ndard]
Selects the Bellcore Caller ID sub-standard.
 [0] = Between rings (default).
 [1] = Not ring related.
Note: For this parameter to take effect, a device reset is
required.
[ETSICallerIDTypeOneSubStanda
rd]
Selects the ETSI FSK Caller ID Type 1 sub-standard (FXS
only).
 [0] = ETSI between rings (default).
 [1] = ETSI before ring DT_AS.
 [2] = ETSI before ring RP_AS.
 [3] = ETSI before ring LR_DT_AS.
 [4] = ETSI not ring related DT_AS.
 [5] = ETSI not ring related RP_AS.
 [6] = ETSI not ring related LR_DT_AS.
Note: For this parameter to take effect, a device reset is
required.