Version 5.8 317 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
Web: Hotline Dial Tone
Duration
EMS: Hot Line Tone Duration
[HotLineToneDuration]
Duration (in seconds) of the Hotline dial tone. If no digits are
received during this duration, the device initiates a call to a user-
defined number (refer to Automatic Dialing on page 143).
The valid range is 0 to 60. The default is 16.
Note: This parameter is applicable to FXS and FXO interfaces.
Time Before Reorder Tone
[sec]
[TimeBeforeReorderTone]
The delay interval (in seconds) from when the device receives a
SIP BYE message (i.e., remote party terminates call) until the
device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Reorder Tone Duration [sec]
[TimeForReorderTone]
The duration (in seconds) that the device plays a Busy or Reorder
tone duration before releasing the line.
The valid range is 0 to 254. The default is 0 seconds.
Typically, after playing a Reorder / Busy tone for the specified
duration, the device starts playing an Offhook Warning tone.
Notes:
The selection of Busy or Reorder tone is performed according to
the release cause received from IP.
Refer also to the parameter CutThrough.
Web: Enable Comfort Tone
[EnableComfortTone]
Determines whether the device plays a Comfort Tone (Tone Type
#18) to the FXS/FXO endpoint after a SIP INVITE is sent and
before a SIP 18x response is received.
[0] = Disable (default)
[1] = Enable
Note: This parameter is applicable only to FXO/FXS interfaces.
[WarningToneDuration]
Defines the duration (in seconds) for which Off-Hook Warning Tone
is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Note: A negative value indicates that the tone is played infinitely.
[FirstCallWaitingToneID]
Determines the index of the first Call Waiting Tone in the Call
Progress Tone (CPT) file. This feature enables the called party to
distinguish between four different call origins (e.g., external versus
internal calls). The device plays the tone received in the 'play tone
CallWaitingTone#' parameter of an INFO message and the value of
this parameter - 1.
The valid range is -1 to 100. The default value is -1 (not used).
Note: It is assumed that all Call Waiting Tones are defined in
sequence in the CPT file.
Precedence Ringing Type
[PrecedenceRingingType]
Defines the index of the Precedence Ringing tone in the Call
Progress Tones (CPT) file. This tone is used when the parameter
CallPriorityMode is set to 1 and a Precedence call is received from
the IP side.
The valid range is -1 to 16. The default value is -1 (i.e., plays
standard Ringing tone).
To Next Page
Loading...
