AudioCodes MP-124 - Page 338

SIP User's Manual 338 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
Notes:
 This parameter can include up to 20 indices.
 For a description of the table's parameters, refer to the
individual parameter descriptions below.
 Several entries with the same NPI-TON or Phone-
Context are allowed. In this scenario, a Tel-to-IP call
uses the first match.
 Phone-Context '+' is unique in that it doesn't appear in
the Request-URI as a Phone-Context parameter.
Instead, it's added as a prefix to the phone number. The
'+' isn't removed from the phone number in the IP-to-Tel
direction.
 To configure the Phone Context table using the Web
interface, refer to ''Mapping NPI/TON to Phone-Context''
on page 128.
 For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' on page 191.
Web/EMS: Add Hunt Group ID as
Prefix
[AddTrunkGroupAsPrefix]
Determines whether the device's Hunt Group ID is added
as a prefix to the destination phone number (i.e., called
number) for Tel-to-IP calls.
 [0] No = Don't add Hunt Group ID as prefix (default).
 [1] Yes = Add Hunt Group ID as prefix to called
number.
Notes:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Hunt Group
IDs (refer to Configuring the Endpoint Phone Numbers
on page 149).
Web: Add Trunk ID as Prefix
EMS: Add Port ID As Prefix
[AddPortAsPrefix]
Determines whether the port number is added as a prefix
to the called number for Tel-to-IP calls.
 [0] No = port number/ not added as prefix (default).
 [1] Yes = port number/ added as prefix.
If enabled, the port number (single digit in the range 1 to 8
for 8-port devices, two digits in the range 01 to 24 for MP-
124) is added as a prefix to the called (destination) phone
number.
This option can be used to define various routing rules.
Add Trunk Group ID as Prefix to
Source
[AddTrunkGroupAsPrefixToSource]
Determines whether the device adds the Hunt Group ID
(from where the call originated) as the prefix to the calling
number (i.e. source number).
 [0] No (default)
 [1] Yes