Avaya IPBS2 - Page 150

150 Avaya 374x DECT Telephones - User Guide 02/2016
Certificate validation is disabled until system
time is set (X509)
System time is not set but the current date is needed
to validate if cryptographic certificates are valid.
Therefore encrypted TLS connections will fail.
Configure a NTP server or set the system time
manually.
0x000c1000 IPBS/
IPBL
X
Certificate expired/Will expire soon (X509)
The device certificate or one of the trusted
certificates has already expired or will expire
during the next 30 days. After the certificate has
expired TLS connections using this certificate will
fail. Replace the certificate with a new one.
0x000c1001 IPBS/
IPBL
X
RFP disconnected (TAM) 0x000e0001 IPBL X
RFP malfunctioning (TAM) 0x000e0002 IPBL X
RFP disabled (TAM) 0x000e0003 IPBL X
RFP software download (Dwl) 0x000e0004 IPBL X
RFP unsynchronized (RFPInit)
Four common reasons:
1. The IPBS has lost contact for nine minutes with
the RFPI used as synchronization source.
2. The IPBS is not PSCN synchronized (Primary
Receiver Scan Carrier Number).
3. The IPBS is not MFN synchronized (Multiframe
Number).
4. The IPBS is not slot number synchronized.
0x000e0005 IPBS X
Synchronization to reference system lost
(RFPInit)
Get the Sync Master to resynchronize to the
reference sync either manually or automatically
(scheduled). To select type of resynchronization
action, see Configure Sync Master IPBS
on
page 110. To resynchronize manually,
see Reference Synchronization
on page 129.
0x000e0006 IPBS X
Other DECT system with same sysid detected
(RFPInit)
0x000e0008 IPBS X
Sync master failed to resynchronize to reference
(RFPInit)
0x000e0009 IPBS X
RFP restarted
Burst mode controller of the IPBS restarted.
0x000e000a IPBS X
High temperature (TAM) 0x000f0001 IPBL X
High power consumption (TAM) 0x000f0002 IPBL X
Supply voltage low (TAM) 0x000f0004 IPBL X
Supply Voltage High (TAM) 0x000f0008 IPBL X
Fan failure (TAM) 0x000f0010 IPBL X